Ensure the front panel cable and the aerosol fan cables are secured inside the right hand cover with cable clamps and retaining clips. At the rear of the right hand side chassis is a hole for the cables to go through. If the cables are not through this hole when the cover is in place on the printer the cover cannot be properly installed.
NOTE
Front Panel Assembly
Removal
1. Remove the Printhead Cleaners (Refer to the User Guide). WARNING Switch off the printer and remove the power cable. 1. Remove the following: 1. "Right Hand Cover" see page 8-4. 2. The Front Panel Assembly and the Front-Panel Assembly Cable can be removed by releasing them from the retaining clips (item 1) and cable clamps (item 2) inside the Right Hand Cover (item 3) (Refer to Figure 2).
3
1
2
C607436
Figure 2: Front Panel
8-6
HP DesignJets 1050C and 1055CM Printers Service Manual
